Balanced Fast Shaft Driveshaft with 8" Standard Yoke

Allow Fastshafts' steel driveshafts to be your unyielding companion. Take them on a fast and furious trip and let their quality components and exacting manufacturing tolerances take you to the limit! Fastshafts builds their strong steel driveshafts using only the best DOM 1020 "driveshaft-quality" tubing on the market. They also expertly balance their driveshafts using only the finest balancing equipment, which includes the most technologically advanced equipment available. All of Fastshafts' steel driveshafts come with standard U-joints. Fastshafts' steel driveshafts are serious components that are built for serious drivers.

Driveshaft Information:
Balanced
Made from DOM 1020 Steel
U-Joints Included
Length: 28 1/2"
Diameter: 2"
Weight: 12.1 lbs
MADE IN THE USA

This driveshaft includes an 8" Slip Yoke. Longer slip yokes help compensate for rear suspension systems with extreme travel, or driveshaft lengths that are slightly shorter than needed.

Yoke Information:
8" Long from center of u-joint to end of yoke.
6" Slip Surface
3 1/4" x 1 1/16" U-Joint Cap Size
Grooved for external snap rings to retain U-joint cups

Yoke fits over the output shaft of the following transmissions:
•Common GM/Saginaw 3 & 4 speed transmissions with a 1-3/16" x 27 spline output shaft
•Powerglide, T-350, 700R-4, 200R-4, and 4L60 automatic transmissions
•Muncie M20/M21 and Borg Warner T-5, T-10 & T-56 27-spline manual transmissions

MADE IN THE USA